Underfloor Insulation in Broxburn: A Ground Floor as Warm as Upstairs
Underfloor insulation for Broxburn and Uphall homes with timber ground floors, usually fitted in a day, and Home Energy Scotland pays up to £1,500 of it if you qualify.
Underfloor insulation
-
The cold void
-
Wool between the joists
-
Netting underneath
-
A warmer floor
Illustration: underfloor insulation, step by step
-
The cold void
-
Wool between the joists
-
Netting underneath
-
A warmer floor
Why Your Broxburn Ground Floor Feels Colder Than Upstairs
Upstairs is warm, yet the living room stays chilly with the radiator turned right up.
If your ground floor is timber, the cold usually comes from below. Underfloor insulation in Broxburn deals with it at the source.
-
Broxburn and Uphall have grown into one town, with older stone houses, post-war homes and new estates side by side.
-
The older houses often have floorboards over an open space.
-
Many newer homes sit on concrete instead, and a slab has no space under it for us to fill.
-
Under a timber floor, little grilles near the bottom of the outside wall (air bricks) keep air moving so the joists (the wooden beams that carry your floorboards) stay dry.
-
That air comes straight from outside, and it rises through the gaps between your boards.
-
Filling the space under the boards won’t cause damp as long as those vents stay open.
-
Mineral wool goes up between the joists on netting, and every vent is left clear, because our underfloor insulation relies on air still moving underneath.
Lifting a whole floor sounds like days of upheaval. If there’s a hatch and space to crawl under the house, the work happens from below, and your carpets and furniture stay put.
Households that qualify can get up to 75% of the job paid by Home Energy Scotland, capped at £1,500 for a floor. You pay the rest, and your quote shows that figure in pounds.
What we actually do
Two ways to insulate your floor, and what each one involves.
There are two ways to insulate a wooden floor with a gap underneath (a suspended timber floor), and the prices are far apart. Here is how each one is done.
From survey to aftercare
How We Work: Underfloor Insulation in Broxburn
-
Step 1
Survey Visit
Calum or Lewis, our surveyor, inspects the joists, the air vents and the way under your floor. A written quote follows, and no date is booked until you say yes.
Survey first Before we recommend either job, we check how your floor is built, the space underneath it and the vents that keep that space dry. -
Step 2: the split
One of two ways, picked for your floor
-
The standard job
We fit Knauf Omnifit 40 insulation between the joists (the timber beams under your floorboards), support it so it can’t sag, and seal the gaps where draughts get in. You get a much warmer floor for roughly half the cost of the airtight job.
-
The airtight job
We lift the floor and rebuild it with hemp insulation between the joists. A membrane on the room side keeps moist indoor air out of the space under the floor, and a second membrane underneath lets damp escape. We tape every joint to stop air leaking through. It gives the best result where your floor allows it.
-
-
Step 3
Insulation Day
Knauf Omnifit 40 mineral wool is fixed on netting between the joists, every vent is checked clear and any boards we lifted go back down. A standard floor is a one-day job.
Air bricks kept clear We keep the air bricks (the small vents low in your outside walls) clear, so air keeps moving under the floor and the timber stays dry.Boards lifted and re-laid If we can’t get under the floor on a standard job, we lift your floorboards and put them back afterwards, taking extra care with old boards. -
Step 4
Your Records and Guarantee
We supply Home Energy Scotland with the installer forms it needs, and the guarantee and the photos are yours to keep with the house deeds.
Grant funding and EPC We help with your Home Energy Scotland grant if you qualify, answer your questions about it, and provide a new EPC after the work where you need one. -
The honest bit: which level your floor needs
The standard job suits most of the floors we see. The airtight job costs more, because we rebuild the whole floor with two membranes and taped joints, and the natural insulation costs more too. We will tell you which one your floor and budget call for, and the choice is yours.
How each system goes in
Underfloor Insulation Fitted Below Your Broxburn Floorboards
Each card below shows one system building up layer by layer, the way we fit it. The pictures are illustrations.
Illustration: standard system
-
The cold void
Each line of light is a gap between your floorboards. Cold air from the air bricks comes up through those gaps and in at the skirtings, into the room you pay to heat.
-
Wool between the joists
We reach the void through one small hatch, and most floors take a day. Knauf Omnifit mineral wool, cut a touch wider than the space between joists, grips them and fills their full depth.
-
Netting underneath
Support netting fixed under the joists holds the wool up, so it can't sag over the years. We photograph it all for you, since you won't be crawling under there to look.
-
A warmer floor
On the first cold Broxburn night after we've been, the boards under your socks feel warmer than they did last winter. Up in the room, the draught at the skirtings eases off and less heat escapes through the floor.
Standard underfloor insulation with Knauf Omnifit
When there is room to work in the void below, we fit it from underneath, so your floorboards stay down and the job is usually done in a day.
Our most popular option and superb value when there is access from below. We work in subfloor spaces as shallow as 350mm, fitting 150 to 200mm Knauf Omnifit 40 rolls friction-cut to fill the full joist depth, lagging the heating pipes and fixing insulation support netting underneath so it never sags. Ventilation is kept clear, airbricks are extended where needed, and every access hatch is insulated and screwed back down. A breathable membrane and airtightness tape can be added for extra performance.
Illustration: hemp system
-
Boards up, one room at a time
We lift the floorboards to open up the joists.
-
A hammock between the joists
A thin sheet is slung between the joists and taped round its edges.
-
Hemp cut to fit
IndiTherm hemp is cut to sit snugly in each hammock.
-
Sealed, then boarded
A taped top sheet goes over the joists, then your boards go back down.
Hemp underfloor insulation with airtightness membranes
Hemp suits you if you want a natural, Scottish-made material and the best airtightness, and you are happy for the boards to come up room by room. It costs more than the standard job because the floor is lifted and every join is taped.
For a natural, higher-end floor we fit IndiTherm hemp, made in Scotland by IndiNature, working room by room. We sling a thin sheet between the joists like a hammock, tape it round the edges and cut the hemp to fit snugly inside it. A second sheet goes over the joists, taped down to keep moist room air out of the floor, before the boards go back. Installed from above it gives the highest performance with no compromise on airtightness.
Illustration: PIR board system
-
Battens at your heating level
25mm treated battens are fixed to the joists at your heating design level.
-
Foil-faced board between the joists
PIR is cut tightly to fit between the joists and rests on the battens.
-
Foam edges, taped joins
Foam seals the perimeter and foil tape covers every join.
-
Heating on top
The pipes go in above the board. Then the floor goes back on top.
PIR insulation for underfloor heating
Underfloor heating laid over a cold, ventilated void loses heat downward unless there is insulation beneath it. A foil-faced foam board (PIR) under the heating sends that warmth back up into the room, where you want it.
We recommend high-performance foil-faced PIR, fitted on 25mm treated battens set to your heating design level and cut tightly between the joists, with airtightness foam sealing the perimeter and foil tape over every join. Most underfloor heating contractors do not hold the TrustMark certification for underfloor insulation, so we carry out this element, which keeps up to £1,500 of Home Energy Scotland grant open to you if you qualify. We are happy to work alongside your contractor or recommend a trusted partner.
Why Broxburn Homeowners Choose Our Underfloor Insulation Installers
-
A straight answer on concrete floors
If your house sits on a concrete slab, we can’t insulate it from below, and we’ll say so plainly.
-
Your quote shows the grant
It sets the full price beside your share after the grant, for mineral wool and for natural hemp if you ask about it.
-
Photos of the hidden work
The crew takes pictures of the finished insulation under the floor and sends them to you, so nobody has to crawl under the house to check.
-
The house left tidy
The crew cleans up before it leaves, and plenty of our Google reviews mention that clean-up by name.
-
Buried vents opened up again
If a patio, path or extension now covers an air brick, a vent extender goes in so air can reach the space under the floor.
-
Registered, so the grant can pay
Grant money for floor insulation only goes to jobs done by an installer on the TrustMark register, and our name is on it. PAS 2030 covers how we fit.
What Underfloor Insulation Costs a Broxburn Household After the Grant
Mineral wool under a standard floor runs £1,400 to £2,500, so with the full grant your share is £350 to £1,000.
- GrantUp to 75%, capped at £1,500, if you qualify
- LoanInterest-free, up to £500
- The grant pays up to 75% of underfloor insulation costs, with floor work capped at £1,500. On a £2,000 floor, 75% comes to exactly £1,500, so you’d pay £500. On anything dearer than £2,000, the grant is still £1,500, however big the job.
- Hemp, the natural option, is £3,000 to £5,000, which the full grant brings down to £1,500 to £3,500. It’s fitted from above with the boards up, then sealed under a thin membrane and tape so wind can’t blow through it.
- Home Energy Scotland handles your application and makes the call on eligibility, so any grant figure in a quote stays an estimate until it replies. Our part is answering its questions and sending the paperwork it needs from the installer.
The floor’s £1,500 counts within a £7,500 maximum per house. Rural and island postcodes get a higher house limit of £9,000, but that only makes a difference on a bigger job with solid wall insulation in it. An optional interest-free loan is there too, up to £500 for a floor.
Three Guarantees on Every Broxburn Floor
PAS 2030 is the standard our crews work to, and we’re a TrustMark-registered installer, which Home Energy Scotland looks for before it funds a floor.
What you get on every floor we insulate:
-
25-year workmanship guarantee
A 25-year workmanship guarantee, in writing.
-
TrustMark and PAS 2030 certified
Audited work that meets the standards the grant requires.
-
No deposit
No deposit, so nothing leaves your account in advance.
-
Payment on 7-day terms
Payment within 7 days of completion, with the bill sent once the crew has packed up.
Ask your own questions about underfloor insulation in Broxburn.
Walk round the outside of your house and look for small grilles low down on the walls, just above the ground. If you find some, your floor is probably timber. Ring us with what you found, and we’ll arrange your free survey from there.
Underfloor Insulation in Broxburn: What Homeowners Ask Us
The questions we hear most.
Between £1,400 and £2,500 for mineral wool on a typical floor. The full grant brings your share down to £350 to £1,000. Hemp is dearer, at £3,000 to £5,000 before the grant.
Book Your Free Survey ↓You pay part of it. Home Energy Scotland pays up to 75% for a household that qualifies, and never more than £1,500 for a floor. The quote shows your share in pounds before you commit.
No, provided the vents under the floor stay open. Air keeps moving below the insulation and carries moisture away. Covered or blocked vents are where damp after underfloor insulation comes from, so each one is checked at the survey.
Book Your Free Survey ↓Not when the crew can get under the house through a hatch. That hatch is what makes underfloor insulation without lifting floorboards possible. If the gap below is too tight to crawl, some boards come up, the insulation goes in from above and the boards are put back down.
Knauf Omnifit 40 mineral wool, held up between the joists on netting. It’s our standard choice for a timber floor. If you’d rather avoid man-made materials, natural hemp is the other option, and it goes in from above once the boards are lifted.
Often, yes. Where both need doing, one crew can take the floor while another does the loft, so it’s all done on a single visit. The survey checks both spaces.
Usually a single day. A tight space or a big house can spill into a second day, and you’ll know which at the survey.
Yes, all three. Our crews travel through from East Kilbride. Older streets and newer estates sit close together around here, so the survey checks which floor you have before anything is priced. A little further south, we also fit underfloor insulation in Livingston.
Book your free underfloor survey.
Tell us about your floor and we will be in touch to arrange a survey.



