Underfloor Insulation in Giffnock and Clarkston: The East Renfrewshire Semi and Bungalow Belt
Underfloor insulation in Giffnock and Clarkston for the interwar semis and bungalows that cover most of both towns: usually one day’s work, with up to £1,500 of it met by Home Energy Scotland if you qualify.
Google Review
-
The cold void
-
Wool between the joists
-
Netting underneath
-
A warmer floor
Illustration: underfloor insulation, step by step
-
The cold void
-
Wool between the joists
-
Netting underneath
-
A warmer floor
The Interwar Boom That Built Giffnock and Clarkston’s Suspended Timber Floors
Cold feet in the front room and a heating bill that keeps climbing often start under the floor.
Giffnock and Clarkston filled up with semis and bungalows between the wars, and those houses usually sit on timber floors over an open gap, known as a suspended timber floor.
-
Air bricks keep that gap ventilated so the joists stay dry, but the same cold air sits right under your boards all winter.
-
A later extension that’s buried an air brick is a common reason a room stays cold.
Underfloor insulation in Giffnock stops the cold from below and leaves the air bricks open, so the timbers stay as dry as they are now. A Giffnock semi or a Clarkston bungalow then holds its heat in the front room, and if you qualify, Home Energy Scotland covers up to 75% of the cost, capped at £1,500.
Floor insulation in Giffnock and Clarkston is the same job in both towns: Knauf Omnifit 40 mineral wool between the joists on support netting, every air brick checked, and a vent extender fitted wherever one’s been buried, the same underfloor insulation system our crews fit from Newton Mearns to Cathcart.
Newer infill sometimes sits on solid concrete rather than joists.
Solid concrete floors aren’t suitable for this measure, and the survey confirms which you have.
The front room in your Giffnock semi or bungalow stops feeling cold underfoot, and the air bricks keep doing their job below it.
What we actually do
Two ways to insulate your floor, and what each one involves.
There are two ways to insulate a suspended timber floor, and they sit at very different price points. The cards below cover both, and what goes into each job.
From survey to aftercare
Our Simple Process
-
Step 1
Free survey and tailored design
Our surveyors come out, work out if the floor’s on joists or slab and how the void behaves. You leave with a written quote: the full price, and the figure left once the grant lands.
Survey first The survey covers the floor construction, the void (the air gap under the boards) and how it is ventilated before we recommend either route. -
Step 2: the split
One of two ways, picked for your floor
-
The standard job
We fit Knauf Omnifit 40 between the joists and support it so it can’t sag, then seal the obvious draught paths. A big comfort gain for roughly half the cost of the airtight job.
-
The airtight job
The floor comes up and goes back rebuilt: hemp insulation between the joists, a vapour-control layer on the warm side that keeps moist room air out of the void, a membrane on the cold side that lets water vapour out, and airtightness tapes throughout. The best result, where it is practical.
-
-
Step 3
Specialist installation
Usually done in a day. The crew sheets the floor first, fits Omnifit 40 on its netting from below wherever the void lets them, and reopens every vent along the way. The room’s hoovered before they pack up, and if you want the loft done too, a second crew can see to it.
Air bricks kept clear We keep the air bricks and ventilation paths clear so the void keeps working and the timber stays dry.Boards lifted and re-laid On a standard job, where there is no access from below, we lift and re-lay your floorboards, and take extra care with period boards. -
Step 4
Handover
The crew leaves the space swept, hands you the set of photographs, and the job is done.
Grant funding and EPC Home Energy Scotland grant funding where you qualify, with help on any questions, and a post-installation EPC where relevant. -
The honest bit: which level your floor needs
The standard job suits most of the floors we see. The fully airtight build-up costs more because the floor is rebuilt with a vapour-control layer, a cold-side membrane and airtightness tapes, and the natural insulation itself costs more. We will tell you which one your floor and budget call for, and leave the choice with you.
Your free survey
Book one visit for your floor, and the loft as well if it needs it.
Tell us which room stays coldest and the survey starts there.
Book Your Free Survey ↓
How each system goes in
Underfloor Insulation Fitted Below Your Giffnock and Clarkston Floorboards
Each card below shows one system building up layer by layer, the way we fit it. The pictures are illustrations.
Illustration: standard system
-
The cold void
Each line of light is a gap between your floorboards. Cold air from the air bricks comes up through those gaps and in at the skirtings, into the room you pay to heat.
-
Wool between the joists
We reach the void through one small hatch, and most floors take a day. Knauf Omnifit mineral wool, cut a touch wider than the space between joists, grips them and fills their full depth.
-
Netting underneath
Support netting fixed under the joists holds the wool up, so it can't sag over the years. We photograph it all for you, since you won't be crawling under there to look.
-
A warmer floor
On the first cold Giffnock and Clarkston night after we've been, the boards under your socks feel warmer than they did last winter. Up in the room, the draught at the skirtings eases off and less heat escapes through the floor.
Standard underfloor insulation with Knauf Omnifit
When there is room to work in the void below, we fit it from underneath, so your floorboards stay down and the job is usually done in a day.
Our most popular option and superb value when there is access from below. We work in subfloor spaces as shallow as 350mm, fitting 150 to 200mm Knauf Omnifit 40 rolls friction-cut to fill the full joist depth, lagging the heating pipes and fixing insulation support netting underneath so it never sags. Ventilation is kept clear, airbricks are extended where needed, and every access hatch is insulated and screwed back down. A breathable membrane and airtightness tape can be added for extra performance.
Illustration: hemp system
-
Boards up, one room at a time
We lift the floorboards to open up the joists.
-
A hammock between the joists
A thin sheet is slung between the joists and taped round its edges.
-
Hemp cut to fit
IndiTherm hemp is cut to sit snugly in each hammock.
-
Sealed, then boarded
A taped top sheet goes over the joists, then your boards go back down.
Hemp underfloor insulation with airtightness membranes
Hemp suits you if you want a natural, Scottish-made material and the best airtightness, and you are happy for the boards to come up room by room. It costs more than the standard job because the floor is lifted and every join is taped.
For a natural, higher-end floor we fit IndiTherm hemp, made in Scotland by IndiNature, working room by room. We sling a thin sheet between the joists like a hammock, tape it round the edges and cut the hemp to fit snugly inside it. A second sheet goes over the joists, taped down to keep moist room air out of the floor, before the boards go back. Installed from above it gives the highest performance with no compromise on airtightness.
Illustration: PIR board system
-
Battens at your heating level
25mm treated battens are fixed to the joists at your heating design level.
-
Foil-faced board between the joists
PIR is cut tightly to fit between the joists and rests on the battens.
-
Foam edges, taped joins
Foam seals the perimeter and foil tape covers every join.
-
Heating on top
The pipes go in above the board. Then the floor goes back on top.
PIR insulation for underfloor heating
Underfloor heating laid over a cold, ventilated void loses heat downward unless there is insulation beneath it. A foil-faced foam board (PIR) under the heating sends that warmth back up into the room, where you want it.
We recommend high-performance foil-faced PIR, fitted on 25mm treated battens set to your heating design level and cut tightly between the joists, with airtightness foam sealing the perimeter and foil tape over every join. Most underfloor heating contractors do not hold the TrustMark certification for underfloor insulation, so we carry out this element, which keeps up to £1,500 of Home Energy Scotland grant open to you if you qualify. We are happy to work alongside your contractor or recommend a trusted partner.
Why Homeowners in Giffnock and Clarkston Pick Us
-
TrustMark lists us by name
TrustMark registration and PAS 2030 accreditation belong to the company, the same for every job. Before you book anyone in Giffnock or Clarkston, look them up on the TrustMark register: TrustMark lists us by name, and we hold the PAS 2030 accreditation Home Energy Scotland checks before it funds underfloor work.
-
saving a second booking and a second round of dust sheets
Ask about the loft at the same survey and one visit can cover both. A second crew comes alongside the underfloor team on the same day, saving a second booking and a second round of dust sheets. Tell us at the survey and we’ll build it into one written quote.
-
not paid more to steer you
The choice between Knauf Omnifit and IndiTherm hemp sits on one quote, decided by you. We’re not paid more to steer you toward either one. Both routes get priced honestly at the survey and the decision is yours to make.
-
the only look they will ever take
Every void gets photographed before the floor is closed back up. For most owners that set is the only look they will ever take at what sits between the joists, and the set comes to you, alongside the installer paperwork Home Energy Scotland needs from our side.
-
is never ours to make
Home Energy Scotland decides who qualifies, house by house, in G46 and G76. We supply the survey details and the installer paperwork HES needs, and the decision on eligibility and on which cap applies is never ours to make.
-
nobody chases you for an answer
No pressure to decide at the survey. You get the written quote and the time to think it over, and nobody chases you for an answer, in Giffnock, in Clarkston or anywhere else we cover.
Underfloor Insulation Grant in Giffnock and Clarkston: What You’ll Pay
Before any grant, underfloor insulation cost in Giffnock and Clarkston comes down to the size of your ground floor and how easy it is to get under.
- GrantUp to 75%, capped at £1,500, if you qualify
- LoanInterest-free, up to £500
- InstallerTrustMark-registered
- The standard Knauf fit runs £1,400 to £2,500, and Home Energy Scotland covers up to 75% of the cost, capped at £1,500 for underfloor if you qualify.
- A single-storey bungalow near the top of that band, around £2,500, gets the full £1,500 grant and leaves you £1,000 to pay.
- A two-storey semi nearer £1,400 stays under the cap, so you get £1,050 of grant and pay £350.
- For a natural material, IndiTherm hemp sits between two thin sheets with every joint taped against draughts. It costs £3,000 to £5,000 before the grant, £1,500 to £3,500 after it if you qualify, since the £1,500 cap doesn’t grow with a dearer material.
- Home Energy Scotland only funds work by a TrustMark-registered installer (we are one), and it alone assesses and decides every grant application.
A rural or island postcode can lift the whole-house cap from £7,500 to £9,000, but your floor grant stays at £1,500 wherever you live. The extra only counts when solid wall insulation goes in as part of the same job, and Home Energy Scotland decides which postcodes qualify. You can also take an optional interest-free loan of up to £500 for the floor, separate from the grant.
Our Guarantees
If your Giffnock or Clarkston floor doesn’t need the work, or another job would help more first, you’ll hear that at the survey.
Three commitments, in writing, on every floor we insulate:
-
25-year workmanship guarantee
We guarantee the workmanship on your underfloor insulation for 25 years.
-
TrustMark and PAS 2030 certified
Audited work that meets the standards the grant requires.
-
No deposit
No deposit, ever, at any stage of the job.
-
Payment on 7-day terms
Payment is due within 7 days of completion, so you’ve seen the work and the photographs before you pay.
Ask your own questions about underfloor insulation in Giffnock.
Tell Calum which room in your Giffnock or Clarkston home stays coldest when you book your free survey, and he or Lewis, our surveyor, will walk the access with you before any work starts. Call if you’d rather talk it through first.
Giffnock and Clarkston Underfloor Insulation: Your Questions Answered
The questions we hear most.
Not always. Draughty floorboards usually point to the void below, and the survey settles the access question before any work starts.
Knauf Omnifit 40 mineral wool on support netting is the standard fit for most of the belt’s semis and bungalows. If you’d rather avoid anything fossil-based, IndiTherm hemp, sealed in with thin sheets and taped joints to stop draughts, is the alternative.
Expect £1,400 to £2,500 before the grant for the standard Knauf system here, or £350 to £1,000 after it if you qualify. The natural hemp route costs more before the grant, and the same £1,500 cap still applies after it. The figure for your floor comes down to its size and how easy it is to get under, which is how underfloor insulation cost is worked out on every survey.
Book Your Free Survey ↓No. The insulation sits between the joists rather than across the void, so the airflow underneath stays untouched. Any air brick we find blocked gets reopened, and the ventilation that’s kept those joists dry for decades keeps working the same way.
Book Your Free Survey ↓One day is usually enough. Dust sheets go down first, and every room the crew’s worked in gets hoovered before they leave. Loft and floor can go in on the same visit if you want both done.
Yes, and quickly: floors feel warmer underfoot within a day, and the effect on your heating bill builds over the following season. We won’t invent a saving percentage for your house, because what underfloor insulation actually does to a cold room turns on its size, its heating and how draughty the boards were.
Yes. Newton Mearns, Thornliebank, Busby, Netherlee and Williamwood are regular ground for us, and so is the stretch from our East Kilbride base through Rutherglen and Cathcart. We’re on TrustMark’s public register, worth checking before you book anyone. We also fit underfloor insulation in East Kilbride, where we’re based. Tell us your postcode and we’ll confirm whether the job is ours.
Book your free underfloor survey.
Tell us about your floor and we will be in touch to arrange a survey.



