Underfloor Insulation in Kirkintilloch: Warm Floors on Both Sides of the Canal
Underfloor insulation in Kirkintilloch that takes a ground floor from draughty to warm in a day, in the weavers’ terraces and colony flats of the old town and the villas west of it, with up to £1,500 of the cost covered by the Home Energy Scotland grant if you qualify.
Google Review
-
The cold void
-
Wool between the joists
-
Netting underneath
-
A warmer floor
Illustration: underfloor insulation, step by step
-
The cold void
-
Wool between the joists
-
Netting underneath
-
A warmer floor
The canal built Kirkintilloch, and its older floors still show it
In February the floor stays cold through your socks, and a draught runs along the skirtings however long the heating is on.
In the older streets around the centre, expect a wooden floor, because those houses went up before concrete floors did.
The 1960s stock at Harestanes and Hillhead can sit on solid concrete, which this method cannot help, and the survey confirms which you have before anyone quotes for insulating suspended timber floors.
-
The older terraces, colony flats and villas along Kirkintilloch’s canal sit on wooden floorboards over an open gap, with vents in the outside wall keeping air moving through it so the timber does not rot.
-
Your heating pays for that cold air.
Suspended timber floor insulation here means Knauf Omnifit 40 mineral wool between the joists on support netting, with the air bricks left open so the floor does not turn damp.
It suits almost every older ground floor in town, and it is how we handle every underfloor insulation job.
Warm boards underfoot and dry timber are what you are after, and underfloor insulation in Kirkintilloch gives you both.
If you qualify, the Home Energy Scotland grant covers up to 75% of the cost, capped at £1,500.
Your ground floor stays warm through February, usually after one day’s work on a standard floor.
What we actually do
The right option for your floor, different solutions explained.
There are two ways to insulate a suspended floor, and they sit at very different price points. The cards below cover both, and what goes into each job.
From survey to aftercare
Our simple process
-
Step 1
Free survey
Calum or Lewis, our surveyor, comes to the house, gets under the floor through a hatch or a lifted board, counts the air bricks outside and confirms the floor type. You get a written quote with the full price, the realistic after-grant figure, and the standard and natural systems priced side by side.
Survey first A survey of the floor construction, the void, and how it is ventilated, so we recommend the right approach for your floor. -
Step 2: the split
One of two ways, picked for your floor
-
The standard job
Knauf Omnifit is fitted between the joists and supported so it can’t sag, with the obvious draught paths sealed. A big comfort gain for roughly half the cost of the airtight version.
-
The airtight job
The whole floor lifted and rebuilt: insulation between the joists, an airtightness membrane on the warm side (a sheet that keeps moist room air out of the floor), a taped membrane on the cold side (one underneath that lets damp escape), and airtightness tapes throughout. The best result, where it is practical.
-
-
Step 3
Installation, usually one day
Dust sheets first. Where there is crawl access the crew works from below and your rooms barely change. Where there is not, boards come up in sections and go back in order. Omnifit 40 goes in on support netting, vents are cleared and extended where needed, and the rooms are hoovered before the crew leaves. If the loft needs doing as well, two crews can fit loft insulation upstairs while the floor crew works below, one visit for both.
Airbricks kept clear We keep the airbricks and ventilation paths clear so the void keeps working and the timber stays dry.Boards lifted and relaid Where there is no access from below, we lift and relay your floorboards carefully, taking care with period boards.
-
Step 4
Aftercare and guarantee
You get the photograph set, the paperwork HES needs from the installer’s side, and a 25-year workmanship guarantee. No deposit is taken, and payment is due within 7 days of completion, after you have seen the photos and walked the floor.
Grant funding and EPC Home Energy Scotland grant funding where you qualify, with help on any questions, and a post-installation EPC where relevant. -
The honest bit: which level your floor needs
The standard job suits most homes. The fully airtight build-up costs more because the whole floor is lifted. We will tell you honestly which your floor and budget call for, not upsell you.
Start with the survey
One visit tells you what your Kirkintilloch floor needs.
Once you have the price, a standard floor is usually one day of work for the crew.
Book Your Free Survey ↓
Patience with the options is a recurring theme in our reviews. This one came after checking us on the Home Energy Scotland quality-assurance lists: “From there, they were extremely patient going through the options for our room in roof and loft insulation. It was a challenging space to work in but they did an excellent job with it. We would recommend them highly.” Tristan Stewart-Robertson, ★★★★★ Google Review
How each system goes in
Underfloor Insulation Fitted Below Your Kirkintilloch Floorboards
Each card below shows one system building up layer by layer, the way we fit it. The pictures are illustrations.
Illustration: standard system
-
The cold void
Each line of light is a gap between your floorboards. Cold air from the air bricks comes up through those gaps and in at the skirtings, into the room you pay to heat.
-
Wool between the joists
We reach the void through one small hatch, and most floors take a day. Knauf Omnifit mineral wool, cut a touch wider than the space between joists, grips them and fills their full depth.
-
Netting underneath
Support netting fixed under the joists holds the wool up, so it can't sag over the years. We photograph it all for you, since you won't be crawling under there to look.
-
A warmer floor
On the first cold Kirkintilloch night after we've been, the boards under your socks feel warmer than they did last winter. Up in the room, the draught at the skirtings eases off and less heat escapes through the floor.
Standard underfloor insulation with Knauf Omnifit
This is the one to pick for a draughty Kirkintilloch floor you want warm for the lowest price.
- 150 to 200mm Knauf Omnifit 40, friction-cut to the full joist depth
- Heating pipes lagged and support netting fixed underneath so nothing sags
- Ventilation kept clear, airbricks extended, access hatches insulated
- Airtightness membrane and tape as an upgrade
Our most popular option and best value on any Kirkintilloch floor with access from below. We work in subfloor spaces as shallow as 350mm.
Illustration: hemp system
-
Boards up, one room at a time
We lift the floorboards to open up the joists.
-
A hammock between the joists
A thin sheet is slung between the joists and taped round its edges.
-
Hemp cut to fit
IndiTherm hemp is cut to sit snugly in each hammock.
-
Sealed, then boarded
A taped top sheet goes over the joists, then your boards go back down.
Hemp underfloor insulation with airtightness membranes
Hemp goes in the same place as any underfloor measure in Kirkintilloch, the ventilated void under your floorboards. For a natural, draught-proof floor we fit IndiTherm hemp room by room, working from above.
- A thin sheet slung between the joists holds the hemp and lets damp out below.
- Edges and joins taped against draughts.
- Hemp cut tight, then a second sheet over the joists to keep moist room air out.
Illustration: PIR board system
-
Battens at your heating level
25mm treated battens are fixed to the joists at your heating design level.
-
Foil-faced board between the joists
PIR is cut tightly to fit between the joists and rests on the battens.
-
Foam edges, taped joins
Foam seals the perimeter and foil tape covers every join.
-
Heating on top
The pipes go in above the board. Then the floor goes back on top.
PIR insulation for underfloor heating
PIR sits under the same kind of floor, a suspended timber deck over a ventilated void that has to keep working. That is the usual construction across older Kirkintilloch stock. With underfloor heating on top, the board sends the warmth back up into the room.
We fit foil-faced PIR on 25mm treated battens set to your heating design level, cut tight between the joists.
- Perimeter sealed with airtightness foam, foil tape over every join
- Not every underfloor heating contractor is TrustMark certified for insulation, so we fit this element and keep up to £1,500 of grant funding within reach, if Home Energy Scotland finds your home eligible
- We work alongside your heating contractor, or recommend one
Why Kirkintilloch homeowners choose us
-
Three house types, one floor.
Weaver’s terraces, colony flats and villas usually sit on joists over a ventilated void.
-
Your original floorboards go back down.
Pre-1919 Kirkintilloch boards are wide softwood, screwed back down in order, no chipboard patchwork.
-
The owner checks every quote.
Calum or Lewis, our surveyor, checks your floor, and Calum answers your questions. Quote written and itemised.
-
When the answer is no, you hear it at the survey.
1960s overspill estates often sit on a concrete slab, which this measure cannot help.
-
You see under your floor without crawling there.
Every job is photographed between the joists before boards close.
-
The register is the gate, and the ruling is not ours.
An installer off the TrustMark register cannot claim HES money. We hold that registration, and we’re PAS 2030 accredited. Home Energy Scotland, run by Energy Saving Trust, rules on every application itself.
Why this is really about airtightness
Underfloor insulation means insulating the gap between your floor joists so the cold void below stops draining heat from the room. That void is ventilated on purpose: moisture moves down from the warm room, evaporates into the subfloor air, and is carried away, which is why the airbricks stay clear. The job is to stop cold air reaching your room while the void stays open.
The standard build-up cuts that cold-air infiltration, a real improvement, but it isn’t airtight on its own.
- Cuts the cold air rising from the void
- Roughly half the airtight cost
- Quick, and the most common choice
- Membrane upgrade available for airtightness
The airtight build-up goes further: a sheet on the room side keeps moist indoor air out, one underneath lets damp escape, and every join is taped.
- Stops cold air leaking in around the insulation
- Keeps moist air out of the structure
- Whole floor lifted, so it costs more
- Not practical for every home
We won’t block the airbricks or seal up the void ventilation to hit a number. That ventilation is what keeps the timber dry, so it stays clear, always.
A warmer, steadier home.
No more draught moving across the floor, a floor that feels warmer underfoot, and rooms that hold their heat for longer.
You feel it most through the colder months, with lower heating bills and a more even temperature across the room.
The underfloor insulation grant: what Kirkintilloch homes actually pay
Home Energy Scotland covers up to 75% of underfloor insulation, capped at £1,500. Worth knowing:
- GrantUp to 75%, capped at £1,500, if you qualify
- LoanInterest-free, up to £500
- A standard job costs £1,400 to £2,500, so a Kirkintilloch home that qualifies pays about £350 to £1,000 after the grant.
- Natural IndiTherm hemp: £3,000 to £5,000, or £1,500 to £3,500 with the grant, where you qualify. Floor size and access decide what underfloor insulation costs in your house.
Loft and floor together: both draw on one £7,500 limit, and you can apply separately for an interest-free loan of up to £500 towards underfloor insulation.
- HES decides every application, so no figure is money in hand until they confirm it.
Rural and island postcodes: an extra £1,500 lifts the whole-house cap to £9,000. The floor stays capped at £1,500, so a Kirkintilloch home only gains from the extra on a bigger job with solid wall insulation in it.
Our guarantees
Three commitments sit under every quote, in writing.
-
25-year workmanship guarantee
For our workmanship on your underfloor insulation.
-
TrustMark and PAS 2030 certified
Audited work that meets the standards the grant requires.
-
No deposit
Ever. Nothing is invoiced until the floor is closed up and finished.
-
Payment on 7-day terms
Payment is due within 7 days of completion, so you check the photographs and walk the floor before any money moves.
Underfloor insulation in Kirkintilloch: your questions answered
Straight answers on cost, access, damp, disruption and grant funding.
Assume you have one in the old town and villa streets west of it: those streets predate concrete floors. Air bricks hide behind Bellevue Road hedges but sit exposed in colony rows, and boards bounce more on a villa’s long span. The survey settles it, free.
Book Your Free Survey ↓Standard Knauf Omnifit 40 costs £1,400 to £2,500. With the grant, if you qualify, a Kirkintilloch home pays £350 to £1,000. Access affects price too: a front-door-only terrace takes longer than a villa you can crawl.
Book Your Free Survey ↓Yes, through Home Energy Scotland, if you qualify: up to 75% of the cost, capped at £1,500 for floor work in any postcode. You can also apply for an interest-free loan of up to £500 towards underfloor insulation. The underfloor insulation grant needs a TrustMark-registered installer, which we are.
Book Your Free Survey ↓No: nothing here seals the void, so air crosses the boards as always. What we fix is whatever has choked the ventilation, a path or drive relaid over an air brick. Vents are cleared and extended. Canal proximity changes nothing.
Book Your Free Survey ↓Sometimes, and the void decides it. With a hatch and crawl depth we work from below, straightforward on villa plots west of the centre. In the terrace rows nearer the Cowgate, boards more often come up in sections.
Knauf Omnifit 40 mineral wool as standard, on support netting between the joists. The natural alternative, IndiTherm hemp with membranes and airtightness taping, costs £3,000 to £5,000, or £1,500 to £3,500 after the grant if you qualify.
Yes, and the countryside between them. Lenzie, Waterside, Twechar, Milton of Campsie and Lennoxtown are all covered, and we fit floor insulation across East Dunbartonshire. At the canal’s other end, we also fit underfloor insulation in Falkirk.
Book your free underfloor survey.
Tell us about your floor and we will be in touch to arrange a survey.



