Underfloor insulation netting holds the insulation tight against your floorboards, and a membrane stops wind blowing the warmth out of it. You will never see either again once the boards are back down. They still decide whether a warm floor stays warm or slowly goes cold again. A membrane can also do harm, because the wrong sheet under a timber floor traps moisture against the joists. This guide covers the hidden parts of an underfloor job in Scotland, because that is where careful installs are won and cheap quotes cut corners.
- Support netting holds underfloor insulation tight against the floorboards, because unsupported batts slump over time and leave a cold air gap where it matters most.
- A wind-tight membrane stops cold air washing heat out of the insulation while still letting moisture escape, and it earns its cost on exposed or very draughty sub-floors.
- Polythene or plastic sheeting on the cold side of a timber floor traps moisture against the joists and can rot them.
- Air bricks stay open on every properly done job, because ventilation is what keeps the joists of a Scottish suspended timber floor dry.
- Our standard underfloor job, netting included, typically costs £1,400 to £2,500, and the hemp and membrane upgrade runs £3,000 to £5,000 before any grant.
- Eligible homes can get Home Energy Scotland grant funding of up to 75% of the cost, capped at £1,500 for underfloor insulation, through a TrustMark-registered installer.
If your floor is cold and you can feel draughts at the skirtings, this is the part of a quote worth reading closely. Below you will find what the netting does, when a membrane is worth paying for, the one material that causes real damage, why the vents never get blocked, and what we fit as standard compared with the upgrade.
What underfloor insulation netting actually does
Support netting stapled along the joists holds the insulation up against the floorboards, seen from the crawl space (left) and above a honeycomb brick sleeper wall (right).
A suspended timber floor is insulated by fitting flexible insulation between the joists, pressed up against the underside of the floorboards. The problem is gravity. Insulation batts have almost no strength of their own.
- A batt is wedged between two joists with nothing underneath it.
- Footsteps and seasonal timber movement work it loose over the years.
- It slumps into the void, and an air gap opens between the insulation and the boards.
- Cold air fills the gap and the room above is cold again. Nobody sees why unless they crawl under and look.
Netting stops that happening. It is stapled to the underside or sides of the joists in a continuous run, forming a hammock that holds the insulation tight to the boards with no slump and no gaps. We photograph the finished floor from underneath, and taut netting in even runs is most of what you see. It is also the quickest way to tell a careful installer from a rushed one.
Two details matter:
- The netting holds the insulation against the boards. It should never sag with it halfway down the joist.
- The insulation fills the joist space edge to edge before the netting goes on. Netting cannot fix gaps cut into the batts.
Membranes: when a wind-tight layer earns its cost
Hemp batts going in between the joists of a bay-window room over a taped membrane (left), and the membrane taped between the joists before the hemp goes in (right).
Netting holds insulation up. A membrane does a different job: it controls air movement.
Sub-floor voids are ventilated on purpose. On exposed sites that means wind crossing the underside of your insulation all winter. Flexible insulation works by trapping still air, so air moving through it carries the warmth away. The trade calls this wind-washing.
A wind-tight membrane fixed across the underside of the joists stops that airflow and still lets water vapour pass through and escape, so the floor can dry the way it always has. People often search for a “breathable membrane” for underfloor insulation, meaning one that blocks the wind and lets moisture through. Those products usually do the job.
On our natural-material jobs we fit Pro Clima membranes with taped joints as part of the system. Airtightness tape around the edge of the floor deals with the draughts at the skirtings that prompt many of these enquiries. Our guide to fixing draughty floorboards covers the gaps between the boards themselves.
- Sheltered void, modest ventilation, snug netted insulation: it performs well without a membrane.
- Exposed, windy or very draughty sub-floor: a membrane earns its cost.
- Who decides: the survey, after a look under your floor. A brochure cannot make that call.
Ask at your free survey whether your floor needs a membrane, and we will answer once we have seen your void.
Book Your Free Survey →“We were delighted to find an installer who uses a natural, non-fossil fuel-based insulation material like sisal. Calum was very helpful, answering all our questions on the phone.”
Amanda Grimm
Underfloor insulation, sisal · Google review
The one thing never to put under a timber floor
Mineral wool on support netting under a suspended timber floor, seen from the void. Nothing seals the underside, so moisture can still leave downwards.
Never put polythene, plastic sheeting or anything else that blocks moisture on the cold side of the insulation.
It is easy to see why people reach for it. Plastic stops draughts, it is cheap, and stapled under the joists it looks tidy. A timber floor, though, needs to let moisture out downwards into the ventilated void.
Some moisture always gets into a floor. Sealed underneath, it condenses against the plastic and sits there, held against the joists and the insulation. The timber stays damp, and damp timber rots.
Both let moisture pass down into the ventilated void and out through the air bricks, so the joists stay dry.
The rule is worth repeating: on the cold side of a timber floor, use materials that let moisture pass, such as netting and wind-tight membranes, and never materials that block it. If a quote mentions polythene, plastic sheeting or a “vapour barrier” below the insulation of a suspended floor, ask why.
Our guide on whether underfloor insulation causes damp goes further into the moisture side of the job.
Ventilation stays open through all of it
A vent extender fitted at the sub-floor wall below netted insulation, so air can still cross the void.
Everything above relies on the void underneath staying ventilated. The air bricks in your outside walls let air move through the void, pick up moisture and carry it out. That airflow has kept your joists dry since the house was built.
So on every job we check and clear the vents. Where garden levels, paths or extensions have half-buried them, we fit vent extenders to restore the airflow. Nothing we install, whether netting, insulation or membrane, blocks the path from one air brick to the next.
We stop draughts at the floor and its edges, where you feel them, and leave the vents clear because the building needs that airflow. An installer who proposes sealing the air bricks to stop the cold getting in is trading your draughts for your joists.
Book a free survey and get a specification that keeps your floor ventilated as well as warmer.
Book Your Free Survey →“Enough time was taken to explain what service was being provided and to answer my detailed questions. Calum knows his business very well. It took 2 days to install the insulation under the floor of my large house along with extended vents and then provide extensive pictures of the work done.”
ronnie erskine
Under floor insulation, large house · Google review
What we fit as standard, and what counts as an upgrade
The upgrade in progress: a Pro Clima DA membrane laid over hemp between the joists (left), and Tescon Vana tape sealing the gap above a vent extender (right).
Our standard underfloor job includes the parts this guide has covered:
- Knauf Omnifit 40 insulation friction-fitted between the joists
- support netting throughout
- vents checked and cleared, with extenders where needed
- photographs of the finished work under the floor, so you can see all of it
That standard job costs £1,400 to £2,500, depending on floor area and access.
of the cost, the most Home Energy Scotland grant funding can cover for an eligible home
the grant cap for underfloor insulation
Home Energy Scotland grant rules, checked 19 August 2026. A TrustMark-registered installer is required.
Home Energy Scotland handles the application and confirms who is eligible, and we help with any questions it raises. An optional interest-free loan, capped at £500 for underfloor insulation, can sit alongside the grant. Our floor insulation grant guide sets out the rules.
The upgrade is the natural system: IndiTherm hemp insulation with Pro Clima wind-tight membranes and taped joints, at £3,000 to £5,000 before any grant. It suits exposed floors and owners who want natural, non-fossil materials throughout. Both options, with the full specification, are on our underfloor insulation service page.
The method behind the whole job is in our guide to insulating suspended timber floors.
- Is support netting included throughout? Unsupported batts slump.
- Does anything go under the joists, and what is it? Polythene or a “vapour barrier” there is a warning sign.
- Does my void need a wind-tight membrane, and why?
- Will the air bricks stay open, with vent extenders where they are buried?
- Will I get photos of the finished floor from underneath?
Frequently asked questions
Membrane and tape around the edge of the floor keep draughts out of the insulation.
Do I need a membrane under floor insulation?
Not always. A sheltered sub-floor with a snug, netted installation performs well without one. A wind-tight membrane earns its cost where the void is exposed or very draughty, because it stops moving air stripping heat out of the insulation and still lets moisture escape.
What netting is used for underfloor insulation?
Support netting, stapled to the joists in continuous runs so the insulation is held tight against the underside of the floorboards. Its job is to stop the insulation sagging for the life of the installation. We fit it as standard on our underfloor jobs.
Can you use plastic sheeting under floorboards?
No. Polythene on the cold side of a suspended timber floor traps moisture against the joists and the insulation, which keeps the timber damp and risks rot. Use materials below the insulation that let moisture through, and keep the sub-floor vents clear.
Will a membrane stop the draughts from my floor?
Partly. The draughts you feel at the skirtings are dealt with by the insulation, the edge detailing and airtightness tape around the floor, with a wind-tight membrane adding protection on exposed floors. The air bricks stay open throughout, because sub-floor ventilation is what keeps the floor structure dry.
Is netting and membrane included in the grant?
Yes, they are part of the installed measure. For eligible homes, Home Energy Scotland grant funding covers up to 75% of the cost of underfloor insulation, capped at £1,500, when a TrustMark-registered installer does the work. Home Energy Scotland assesses each application.
Bring any question about your own floor to the free survey, and we will answer it after a look underneath.
Book Your Free Survey →“Communication was very good and the completed invoice showing payment was sent quickly for forwarding to Home Energy Scotland.”
Jim Mulligan
Underfloor insulation · Google review
Get the under-the-floor details right
The parts of an underfloor job you never see decide how long it keeps working. A free survey tells you what your void needs: netting only, or netting plus a wind-tight membrane, and what the grant could cover if you are eligible.
Bring the questions above with you.
Or call us on 0141 465 5812







